Base Unit Settings
Helpline Tel.No. : U.K. 08700 100 076 R.O.I. 01289 8333 27
Before programming, please follow steps 1 to 3 of ‘Base Unit Settings’.
Select Pause Timing
Set the 4 - Digit Base
Unit PIN
Selecting Time Break
Recall (TBR) / Earth
Recall Mode (option)
The factory setting is time break
recall (TBR). If your PBX requires
earth recall mode, this can be added
at an extra cost. Please contact our
Customer Care Helpline for details.
ZZCC
.
Enter PIN.
ZZBB
then
BB
for earth mode
OR
ZZBB
then
AA
for time break
recall mode (TBR).
ZZVV
.
You can change the 4 - digit password
for the base unit. The factory preset
is 0000.
ZZEE
.
Enter PIN.
Enter New PIN (4 digits) twice.
If entered incorrectly, an error tone
sounds.
If entered correctly, a confirmation
tone sounds.
! Once you have programmed
the password, you cannot
confirm it. We recommend you
write down the password. If you
forget it, please consult our
Panasonic Customer Care
Helpline.
U.K. 08700 100 076
R.O.I. 01289 8333
You can select which Message Centre
sending number you want to use. For
example during a promotional period
with your SMS service provider, you
are requested to change from
Message Centre 1 to 3.
ZZCC
.
Enter PIN.
ZZFF
.
ZZAA
to select Message Centre 1
OR
ZZCC
to select Message Centre 3.
ZZVV
.
Selecting SMS Message
Sending Number
You can set the pause timing to 3 or 5
seconds, depending on your PBX
requirements (see “Dialling Pause”).
ZZCC
.
Enter PIN.
ZZCC
.
ZZAA
to select 3 seconds
OR
ZZBB
to select 5 seconds.
ZZVV
.
To Next Page
Loading...
