Why does the alarm sound during a conversation with a weak signal on my Panasonic Telephone?
If the alarm sounds during a conversation while receiving a weak radio signal on your Panasonic Telephone, it means the radio signal is weak. Try moving closer to the CS.
What does "CS Busy" mean on Panasonic Telephone?
If your Panasonic Telephone displays "CS Busy", it means the radio channel is busy. Please try again later.
Why can't I dial on my Panasonic Telephone?
If you cannot dial on your Panasonic Telephone, it might be because the number you dialed is restricted by the system, so you should consult your dealer. Alternatively, the key lock mode might be set. To cancel the mode, press the Function button for about 2 seconds. Also, the radio channel might be busy or a radio communication error occurred, so try again later.
Why is my Panasonic Telephone PS not working?
If your Panasonic Telephone's PS does not work, it could be because the battery is empty. In this case, charge the batteries fully. If the PS has been cancelled or not registered, you should consult your dealer.
What does "REGISTER UNIT" mean on Panasonic Telephone?
If your Panasonic Telephone displays "REGISTER UNIT", it means the PS is not registered in the system. Consult your dealer.
What to do if I can't originate an outside call, Call Transfer, or Conference on Panasonic Telephone System?
If you're unable to make outside calls, transfer calls, or initiate conferences on your Panasonic Telephone System, the CO button might not be programmed on your proprietary telephone. Program the CO button to resolve this.
What to do if Panasonic Telephone System does not ring?
If your Panasonic Telephone System isn't ringing, check the ringer volume selector. If it is set to "OFF", set it to "HIGH" or "LOW".
Why speed dialling does not function on my Panasonic Telephone System?
If Speed Dialling or One-Touch Dialling isn't working on your Panasonic Telephone System, it might be due to bad programming. You should enter the outside line access number (9/ 0, 81 through 88) into programming.
Why doesn't my Panasonic Telephone show a strong radio signal?
If the display on your Panasonic Telephone does not show a strong radio signal even though you are near the CS, the PS user can normally still make calls. The current linked CS is still connected even though another CS is closer.
Why does the battery icon flash during a conversation on my Panasonic Telephone?
If the battery icon flashes or beeping tones sound every 5 seconds during a conversation on your Panasonic Telephone, it indicates that the battery is low. Charge the batteries fully.
To Next Page
General