For the KX-TDA0142 User only:
3. Wrap the cable once around the ferrite core. Then close the case of the ferrite core.
Note
If you need to open the ferrite core, use a flathead screwdriver to unlatch the case of the ferrite core.
Registering the PS
The
PS must be registered to the PBX before it can be used. Programming of both the PS and PBX is required.
A Proprietary Telephone (PT) with multiline display (e.g., KX-T7636 6-line display) is required to perform the
PBX system programming.
Note
For details about system programming using a PT, refer to
"PT Programming" in the Feature Guide,
and "PT Programming" in the PT Programming Manual for your PBX.
48 Quick Installation Guide
7 Connecting a Cell Station to the PBX
To Next Page
