To Next PageTo Next Page
What to do if the telephone does not work using the personal settings or with other settings on Panasonic?
If the telephone doesn't work with personal settings, the previous telephone's settings might not have been cleared. Clear the settings and then programme your desired settings again.
Why is the line disconnected while talking to an outside party on Panasonic?
If the line is disconnected while talking to an outside party, the time limit may have run out. Consult your dealer to extend the time, if necessary.
Why can't I register the PS on my Panasonic PBX?
If you can't register the PS (Personal Station) on your Panasonic PBX, it might be due to a wrong PIN or a connection issue. First, make sure that you register the correct PIN set in the Hybrid IP-PBX into the PS. Then, check the cable connection of the CS (Cell Station) to ensure it's properly connected with the correct pin assignments and free from short circuits.
What to do if Panasonic Hybrid IP-PBX does not operate properly?
If your Panasonic PBX is not operating properly, try using the Reset Button.
How to fix a Panasonic PBX extension that does not operate?
To resolve the issue of an extension not operating on your Panasonic PBX, try the following: * Exchange the extension card with a known working one. * Check the connection between the PBX and the telephone, repairing it if necessary. * Ensure you're using a 2-wire cord. * For telephones with an A-A1 relay, set the switch to the "OUT" or "OFF" position. * Test the telephone on a known working extension port; if it still fails, replace the telephone. * Verify that the PSU is the correct type and replace it if needed. The cause may be a bad extension card, a faulty connection, an incorrect telephone relay setting, a bad telephone, or the wrong type of PSU.
What to do if my Panasonic KX-TDA30 shows improper operation?
If your Panasonic PBX exhibits improper operation, press the Reset Button.
What to do if the parallelled single line telephones do not ring for Panasonic Telephone?
If the parallelled single line telephones do not ring, check if 'No ring' is selected in the settings. If so, change the setting to allow the phone to ring.
What to do if the ALARM indicator on my Panasonic PBX is red?
If the ALARM indicator on the front of your Panasonic PBX cabinet turns red, it indicates a major system error. Check the error log using the Maintenance Console to diagnose the issue.
What to do if my Panasonic KX-TDA30 does not operate properly?
If your Panasonic PBX isn't operating properly, try the following: * Press the Reset Button. * Turn the power switch off, then back on. * Turn off the power switch, unplug the PBX, wait 5 minutes, then plug it back in and turn the power switch back on.
Why can't I make outside calls or transfer calls on my Panasonic phone?
If originating an outside call, call transfer, or conference cannot be performed on your Panasonic telephone, program the CO button. Refer to "1.20.2 Flexible Buttons" in the Feature Guide.
General| Number of users | 52 user(s) |
|---|---|
| DECT connectable | Yes |
| Number of DECT cell stations | 4 |
| RS-232 ports | 1 |
| RJ-11 ports quantity | 2 |
| AC input voltage | 110-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 55 W |
Weight and Dimensions| Weight | 3500 g |
|---|---|
| Dimensions (WxDxH) | 275 x 117 x 376 mm |
