1.1 Introduction
10 PT Programming Manual
Table 2 (Option mode)
[Example of Entering Characters]
To enter "Ann":
Notes
• To erase the character on the cursor, press CLEAR.
• To move the cursor to the left, press .
• To move the cursor to the right, press . When entering two or more characters that use
the same button consecutively (e.g. "G" and "I"), you must press this button or the FWD/DND
button after entering the first character.
• If SELECT is pressed, the characters for each button will be displayed in reverse order.
• To toggle between Table 1 and Table 2 when using KX-T7600 series or KX-NT136, press
the leftmost soft button.
A
nn
6
(5 times)
6
(5 times)
2
FWD/DND
OR
To Next Page
Loading...
