Why is there noise on external paging with my Panasonic KX-TDA50?
Noise on external paging with a Panasonic PBX is often due to induced noise on the wire between the PBX and the amplifier. To resolve this, use a shielded cable as the connection wire. A short shielded cable is recommended.
What to do if Panasonic KX-TDA50 PBX does not operate properly?
If your Panasonic PBX isn't working correctly, try these steps: * Press the Reset Button. * Turn the power off and then back on. * Unplug the PBX for 5 minutes, then plug it back in and turn it on.
Why does my Panasonic Telephone System disconnect during outside calls?
The line may be disconnecting because the time limit has run out. If necessary, consult your dealer to extend the time limit.
What to do if my Panasonic Telephone System does not respond when buttons are pressed?
If your Panasonic Telephone System is not responding when buttons are pressed, it could be due to a couple of reasons. First, the telephone might be locked, in which case you should unlock it. Alternatively, your telephone might be connected to an eXtra Device Port, and in this case system programming is required, so you should consult your dealer.
What causes distorted external music on Panasonic KX-TDA50 PBX?
Distorted external music on your Panasonic PBX is likely due to an excessive input level from the external music source. Decrease the output level of the external music source using the volume control on the music source.
What to do if Panasonic KX-TDA50 PBX Alternate Calling—Ring/Voice and Live Call Screening (LCS) do not function as set when using a Wireless Phone?
Voice-calling mode and Hands-free mode with LCS are not available with Wireless Phones on Panasonic PBX. Switch the calling mode to ring-calling or set the LCS mode to "Private".
Why is my Panasonic PBX displaying 'Restricted'?
If you hear a reorder tone or see "Restricted" displayed on your Panasonic PBX, it could be due to several reasons. Your telephone might be locked, so try unlocking it. Toll restriction could be activated, in which case you should consult your manager or dealer. Alternatively, an account code might be required.
Why some Panasonic PBX features do not work?
If some features on your Panasonic PBX phone aren't working, it could be because system management has restricted those features; consult your manager. It's also possible that the feature numbers have changed, so confirm the revised number and try again.
Why does redialing not function on my Panasonic Telephone System?
Redialing may not function on your Panasonic Telephone System if the stored number was more than 32 digits or an extension number.
How to fix Panasonic Telephone System when personal settings do not work?
If your Panasonic Telephone System does not work using the personal settings or with other settings (One-touch dialing, forwarding destination, etc.), it is possible that the extension line has been changed. The previous telephone’s settings have not been cleared, so clear the settings and then program your desired settings again.
To Next Page
General