Panasonic KX-TDE100

2.1 PT Programming
2.1.1 Programming Instructions
Required Telephone/Extension
PBX settings can be customized through system programming by using a proprietary telephone (PT) with a
multiline display, such as the KX-NT343 or KX-NT346. To access system programming, the Class of Service
(COS) assigned to the PT’s extension must be programmed to allow system programming, or the PT must be
connected to the lowest-numbered port on the card installed in the lowest-numbered slot.
Only one system programming session can be performed at a time. This means that only one user can access
system programming at a time, whether through a PT or PC.
For a list of characters that can be entered during system programming, see Section 1.1.3 Entering
Characters.
Buttons and Functions
Fixed Buttons
Function
KX-NT300/KX-DT300 KX-NT136/KX-T7600 KX-T7200/KX-T7400
*1
REDIAL
PREVIOUS
SP-PHONE
NEXT
FWD/DND
(Page up)
CONF
(Page down)
AUTO DIAL
STORE
ENTER
—
Back to Previous Menu
(CANCEL)
SHIFT
SHIFT
SHIFT
SHIFT
PAUSE
PAUSE
PROGRAM PAUSE
PROGRAM
HOLD
HOLD
END
AUTO ANS
MUTE
MESSAGE
MUTE
AUTO ANSWER MESSAGE
SELECT
14 PT Programming Manual Document Version 2009-12
2.1.1 Programming Instructions