2.4 Fault Recovery/Diagnostics
448 Feature Guide
2.4.5 Dynamic Host Configuration Protocol (DHCP) Assignment
Description
It is possible to assign this PBX as a Dynamic Host Configuration Protocol (DHCP) client, allowing IP
addresses to be received from a DHCP server over a LAN.
Conditions
• It is possible to enable this feature through system programming.
WARNING
It is important to set your DHCP server to not change the IP addresses of the IPCMPR and DSP cards
once IP telephones are registered to the PBX. The IP telephones will not operate properly if these IP
addresses are changed.
Programming Manual References
PC Programming Manual
2.7.4 [1-1] Slot—IPCMPR Card Property—LAN Setting
→ DHCP Client
→ IP Address for IPCMPR Card
→ IP Address for VoIP-DSP
PT Programming Manual
None
To Next Page
Loading...
