Programming
20
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 20)
– using the direct commands (page 22)
L Direct command is the main method used in these operating instructions.
Programming by scrolling through the display menus
1
{MENU}
2 Press {V} or {^} to select the desired main menu. i {SELECT}
3 Press {V} or {^} to select the desired item in sub-menu 1. i {SELECT}
L In some cases, you may need to select from sub-menu 2. i {SELECT}
4 Press {V} or {^} to select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {■} (EXIT) on the base unit or {OFF} on the handset.
Note:
L See page 22 for the default settings.
Base unit
*1 If you program these settings using the base unit, you do not need to program the same item using a
handset.
= Base unit / Y Handset
Main menu Sub-menu 1 Sub-menu 2 Page
Caller list
W
––28
Set answering
s
Screen call –30
Initial setting
"
Ringer setting Ringer volume 14
Ringer tone –
Night mode
– On / Off
– Start / End
25
Call block
*1
–26
LCD contrast ––
Display language –12
Customer support
!
–––
TG106xC(e).book Page 20 Wednesday, February 25, 2009 11:13 AM
To Next Page
Loading...
