Panasonic KX-TG1061C

Answering System
33
listening to your messages remotely. The default
setting is “111”.
1 {MENU} i {#}{3}{0}{6}
2 Enter the desired 3-digit remote access code.
i {SAVE} i {OFF}
Using the answering system
remotely
1
Dial your phone number from a touch-tone
phone.
2 After the greeting message starts, enter your
remote access code.
L The unit announces the number of new
messages.
L The voice guidance announcements are
different depending on the voice guidance
language setting (page 12).
3 Follow the voice guidance prompts as
necessary or control the unit using remote
commands (page 33).
4 When finished, hang up.
Note:
L You can also leave a message just as any
outside caller can. After the greeting message
starts, press {*} to skip the greeting message
and record your message after the beep.
Voice guidance
During remote operation, the unit’s voice guidance
starts and prompts you to press {1} to perform a
specific operation, or press {2} to listen to more
available operations. Operations are presented by
voice guidance in the following order:
– Play back all messages
– Play back new messages
– Record your message
– Erase all messages
– Record your greeting message
Note:
L If you do not press any dial keys within 10
seconds after a voice guidance prompt, the unit
disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for the
voice guidance to prompt you.
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
*2 To resume operation, enter a remote command
within 3 seconds, or the voice guidance starts.
*3 Unit resets to a pre-recorded greeting message.
Turning on the answering system
remotely
If the answering system is off, you can turn it on
remotely.
1 Dial your phone number from a touch-tone
phone.
2 Let the phone ring 15 times.
L A long beep is heard.
3 Enter your remote access code within 10
seconds after the long beep.
L The greeting message is played back.
L You can either hang up, or enter your
remote access code again and begin
remote operation (page 32).
Y Handset
Key Operation
{1} Repeat message (during
playback)
*1
{2} Skip message (during playback)
{4} Play new messages
{5} Play all messages
{6} Play greeting message
{7} Record a greeting message
{9} Stop recording
Stop playback
*2
{0} Turn answering system off
{*}{4} Erase currently playing message
{*}{5} Erase all messages
{*}{6} Erase greeting message (during
greeting message playback)
*3
{*}{#} End remote operation (or hang up)
TG106xC(e).book Page 33 Wednesday, February 25, 2009 11:13 AM