Copying phonebook from a
cellular phone (phonebook
transfer)
You can copy phonebook entries from the paired
cellular phones or other cellular phones (not
paired) to the unit’s phonebook. A cellular phone
must be compatible with Bluetooth wireless
technology.
Important:
R Your cellular phone must support Phone Book
Access Profile (PBAP) or Object Push Profile
(OPP) specification.
R If a copied entry has 2 or more phone numbers,
each phone number (6 max.) is stored as a
separate entry with the same name.
R If a phonebook entry includes additional data
such as a picture, that entry may fail to copy to
the base unit.
R If your cellular phone includes international call
entries, set the conversion codes before
copying (page 52).
Handset / Base unit
1 MMENUN#618
2 To copy from paired cellular phones:
MbN: Select the desired cellular phone. a
MSELECTN
R Copied items are stored to the group
(“Cell 1” or “Cell 2”) which the cellular
phone is paired to.
To copy from other cellular phones (not
paired):
MbN: “Other cell” a MSELECTN a MbN:
Select the group you want to copy to. a
MSELECTN
3 When “Use the cell to transfer
phone book” is displayed:
Go to step 4.
When “Select mode” menu is displayed:
MbN: Select “Auto” or “Manual”. a
MSELECTN
“Auto”: Download all entries from the cellular
phone automatically. Go to step 5.
“Manual”: Copy entries you selected.
R “Select mode” menu is displayed only
when the cellular phone supports PBAP
(Phone Book Access Profile) for Bluetooth
connection.
R Some cellular phones may require you to
perform an operation on the cellular phone
even if you select “Auto”.
4 Cellular phone:
Follow the instructions of your cellular phone
to copy phonebook entries.
R For other cellular phones (not paired), you
need to search for and select the base unit.
The Bluetooth PIN (default: “0000”) may
be required. If your cellular phone shows
PassKey confirmation on its display, follow
the directions to proceed.
R The entries being copied are displayed on
the unit.
5 Wait until “Completed” is displayed.
6 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Note:
R Some copied entries may have characters
which do not exist in the character table
(page 31). These characters can be displayed
but cannot be entered when editing an entry.
R The unit does not support some characters. If a
copied entry includes those characters, they are
replaced with other available characters or “H”.
R If you receive a call while copying phonebook
entries, the copying procedure stops. Try again
after finishing the call.
Setting conversion codes
You must first set the following 3 dialing codes in
the base unit which you want to copy to before
transferring the phonebook from your cellular
phone (each 4 digits max.).
– “International code”: An international
prefix used when you make an international call.
– “Country code”: Your country code for
international calls.
– “Trunk prefix”: A trunk prefix; the initial
digit(s) to be dialed in a domestic call, prior to
the area code.
You can configure this setting using either the
base unit or one of the handsets.
Handset / Base unit
1 MMENUN
2 To store “International code”:
#117
To store “Country code”: #118
52
For assistance, visit www.panasonic.ca/english/support
Using Bluetooth® Devices
To Next Page
Loading...
