Panasonic KX-TG153CSK - Getting Started; Connections; Handset Battery Installation; Handset Battery Charging

Setting up
Connections
R If you do not connect the telephone line cord
and use only cellular lines, set the cellular line
only mode to use this unit more conveniently
(page 18).
n Base unit
Connect the AC adaptor to the unit by
pressing the plug firmly.
Connect the telephone line cord to the unit
until you hear a click.
Fasten the AC adaptor cord and the telephone
line cord by hooking it.
Connect the AC adaptor to the power outlet.
Connect the telephone line cord to the
single-line telephone jack (RJ11C) until you
hear a click.
A DSL/ADSL filter (not supplied) is required if
you have a DSL/ADSL service.
Connect the corded handset cord to the
corded handset and the base unit until you
hear a click.
7
7
1
4 6
5
1
2
3 3
3
Note:
R Use only the supplied Panasonic AC adaptor
PNLV226.
R Follow the directions on the display to set up
the unit.
n Charger
Connect the AC adaptor to the power outlet.
1
Handset battery installation
R USE ONLY rechargeable Ni-MH batteries AAA
(R03) size (
1
).
R Do NOT use alkaline/manganese/Ni-Cd
batteries.
R Confirm correct polarities (
, ).
1
R Follow the directions on the display to set up
the unit.
Handset battery charging
Charge for about 7 hours.
R Confirm “Charging” is displayed (
1
).
R When the batteries are fully charged, “Fully
charged” is displayed.
1
For assistance, visit www.panasonic.ca/english/support
9
Getting Started
TG153CSK(en)_0422_ver021.pdf 9 2016/04/22 14:54:40