Making cellular calls
Important:
R The unit can be used to talk on 2 lines at the
same time (for example, 2 cellular lines, or the
landline and 1 cellular line).
R Only 2 Bluetooth devices can be used with the
unit at the same time (for example, 2 cellular
lines, or the headset and 1 cellular line).
R Before making calls, confirm that the
corresponding
on the handset is displayed
(page 13).
1 Lift the handset and dial the phone number.
R To correct a digit, press MCLEARN.
2 MCELLN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make cellular calls
(page 19).
Go to step 4.
3 MbN: Select the desired cellular phone. a
MSELECTN
4 When you finish talking, press MOFFN or place
the handset on the charger.
Note:
R To switch to the speaker, press MZN.
To switch back to the receiver, press MZN/M
N.
Adjusting the receiver or speaker volume
Press MDN or MCN repeatedly while talking.
Note:
R The receiver or speaker volume you set is kept
for each line (landline and cellular lines).
Making a cellular call using the redial list
The last 5 phone numbers dialed are stored in the
redial list (each 48 digits max.).
1 MEN REDIAL
2 MbN: Select the desired phone number.
3 MCELLN
R The unit starts dialing when:
– only 1 cellular phone is paired.
– a specific line is set to make cellular calls
(page 19).
4 MbN: Select the desired cellular phone. a
MSELECTN
Erasing a number in the redial list
n When a cellular phone is paired:
1 MEN REDIAL
2 MbN: Select the desired phone number. a
MMENUN
3 MbN: “Erase” a MSELECTN
4 MbN: “Yes” a MSELECTN
5 MOFFN
n When a cellular phone is not paired:
1 MEN REDIAL
2 MbN: Select the desired phone number. a
MERASEN
3 MbN: “Yes” a MSELECTN
4 MOFFN
Making landline calls
1 Lift the handset and dial the phone number.
R To correct a digit, press MCLEARN.
2 M
N
3 When you finish talking, press MOFFN or place
the handset on the charger.
Using the speakerphone
1 Dial the phone number and press MZN.
2 When you finish talking, press MOFFN.
Note:
R To switch back to the receiver, press MZN/M
N.
Making a call using the redial list
The last 5 phone numbers dialed are stored in the
redial list (each 48 digits max.).
1 MEN REDIAL
2 MbN: Select the desired phone number.
3 M
N
Pause (for PBX/long distance service users)
A pause is sometimes required when making calls
using a PBX or long distance service. When
storing a calling card access number and/or PIN in
the phonebook, a pause is also needed
(page 34).
Example: If you need to dial the line access
number “9” when making outside calls with a PBX:
20
For assistance, visit www.panasonic.ca/english/support
Making/Answering Calls Using the Handset
To Next Page
Loading...
