Erasing the set phone number
Handset
1 MMENUN#338
2 MbN: “Notification to” a MSELECTN
3 MMENUN a MbN: “Erase” a MSELECTN
4 MbN: “Yes” a MSELECTN a MOFFN
R The new message alert setting is turned off.
Base unit
1 MMENUN#338
2 MbN: “Notification to” a MSELECTN a
MERASEN
3 MbN: “Yes” a MSELECTN a MEXITN
R The new message alert setting is turned off.
Activating/inactivating the remote access code
to play messages
If you activate this feature, you must enter the
remote access code (page 61) to play the new
message from the new message alert call. This is
so that unauthorized parties cannot listen to your
messages. The default setting is “Inactivate”.
– “Inactivate”: You can listen to the message
by pressing 4 to play new messages (without
entering the remote access code).
– “Activate”: You must enter your remote
access code and then press 4 to play new
message.
Handset / Base unit
1 MMENUN#338
2 MbN: “Remote code” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Listening to messages
After you answer the new message alert, you can
listen to the messages as follows.
n When the remote access code is set to
“Inactivate”:
Press 4 to play the new message during the
announcement.
n When the remote access code is set to
“Activate”:
1 Enter the remote access code (page 61)
during the announcement.
2 Press 4 to play the new message.
Note:
R Within 10 seconds after listening to new
messages, you can press #9 during the call
to turn off the new message alert by a call
feature.
R Even if the unit makes a new message alert call,
the handset redial list does not show the record.
However, on the base unit redial list it is shown
as “Message alert”.
Remote operation
Using a touch-tone phone, you can call your
phone number from outside and access the unit to
listen to messages or change answering system
settings. The unit’s voice guidance prompts you to
press certain dial keys to perform different
operations.
Remote access code
A 3-digit remote access code must be entered
when operating the answering system remotely.
This code prevents unauthorized parties from
listening to your messages remotely. The default
setting is “111”.
You can configure this setting using either the
base unit or one of the handsets.
Important:
R To prevent unauthorized access to this product,
we recommend that you regularly change the
remote code.
Handset / Base unit
1 MMENUN#306
2 Enter the desired 3-digit remote access code.
3 MSAVEN
4 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Deactivating remote operation
Press * in step 2 on “Remote access code”,
page 61.
For assistance, visit www.panasonic.ca/english/support
61
Answering System for Landline
To Next Page
Loading...
