Panasonic KX-TG1811 - Registering a Handset; Changing the Pin

21
Useful Information
Pressing {R} does not
display/dial the last
number dialled.
L The redialled number was more than 24 digits long. Redial
the number manually.
I fully charged the
batteries, but 074
still flashes.
L Clean the charge contacts and charge again (page 9).
L It is time to replace the batteries (page 9).
I fully charged the
batteries, but the
operating time seems to
be short.
L Wipe the battery ends (S, T) and the unit contacts with a
dry cloth. Charge the batteries for 7 hours before reuse.
Caller information is not
displayed.
L You must subscribe to Caller ID service.
L Your unit is connected to a telephone line with ADSL
service. We recommend connecting a filter (contact your
ADSL service provider) to the telephone line between the
base unit and the telephone line socket.
L Caller has withheld information.
I cannot remember the
PIN.
L Change the PIN (page 21).
Registering a handset Changing the PIN
1
{j/OK} i “SETTING HS” i {>}
2 “REGISTRATION” i {>}
3 “REGISTER HS” i {>}
4 Press and hold {x} on the base unit for
about 5 seconds.
L If all registered handsets start ringing,
press {x} to stop, then start again
from step 1.
L The rest of the procedure must be
completed within 1 minute.
5 Press {e} or {v} to select a base unit
number. i {>}
6 Wait until “BS PIN” is displayed. i
Enter base unit PIN (default: “0000”).
i {>}
L If you forget your PIN, see page 21.
L A confirmation tone will sound, and
w will stop flashing.
L If w is still flashing, start again from
step 1.
Handset PIN:
1 {j/OK} i “SETTING HS” i {>}
2 “OTHER OPT” i {>}
3 “HSPIN CHANGE” i {>} i
{*}{7}{0}{0}{0}
4 Enter the new 4-digit handset PIN.
5 Enter the new 4-digit handset PIN
again. i {ih}
Base unit PIN:
1 {j/OK} i “SETTING BS” i {>}
2 {5} i {*}{7}{0}{0}{0}
3 Enter the new 4-digit base unit PIN.
4 Enter the new 4-digit base unit PIN
again. i {ih}
Problem Cause & solution
TG1811_1812_1813AL(e-e).book Page 21 Friday, May 12, 2006 2:25 PM