Useful Information
41
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
*1 KX-TG4382/KX-TG4392/KX-TG4393/KX-TG4394
*2 KX-TG4391/KX-TG4392/KX-TG4393/KX-TG4394
Display message Cause/solution
Busy
or
System is busy.
Please try again
later.
L The called handset
*1
or base unit
*2
is in use.
L Other units are in use and the system is busy. Try
again later.
*1
L The handset you are using is too far from the base
unit. Move closer and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 46).
Check tel line L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
Don’t use this
battery.
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 5, 13.
Error!! L The handset’s registration has failed. Move the
handset and base unit away from all electrical
appliances and try again.
Insert battery L The handset was placed on the base unit or charger
without batteries. Insert the batteries properly (page
13).
Invalid L There is no handset registered to the base unit
matching the handset number you entered.
*1
L The handset is not registered to the base unit. Register
the handset (page 46).
No link to base.
Reconnect AC
adaptor.
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 46).
Phonebook full L The phonebook memory is full. Erase unnecessary
entries (page 20).
Store VM access# L You have not stored the voice mail access number.
Store the number (page 36).
TG43xxAL(e)_OI.book Page 41 Friday, May 23, 2008 3:51 PM
To Next Page
Loading...
