Programming
24
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programming using the direct commands
1
8 i {#}
2 Enter the desired code.
3 Select the desired setting. i M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {ic}.
Note:
L In the following table, < > indicates the default settings.
Feature Code Setting System
*1
Page
Caller List {2}{1}{3} ––30
Set Date/Time {1}{0}{1} – r 16
Alarm {7}{2}{0}{1}: Once {2}: Daily
{0}: <Off>
–27
Time
Adjustment
*2
{2}{2}{6}{1}: <Caller ID>
{0}: Manual
r –
Intercom {2}{7}{4} ––39
Ringer Volume
*3
(Handset)
{1}{6}{0}{1}–{6}: Level 1–6 <6>
{0}: Off
––
Ringer Volume
*4
(Base unit)
{*}{1}
{6}{0}
{1}–{6}: Level 1–6 <3>
{0}: Off
r –
Ringtone
*5,
*6
(Handset)
{1}{6}{1} <Ringtone 1>––
Handset Name {1}{0}{4} ––27
Caller Barred
*4
{2}{1}{7} – r 27
Transmission
Power
{7}{2}{5}{1}: <Normal>
{2}: Low
r 16
LCD & Key
Backlight
{2}{7}{6}{1}: <On> {0}: Off ––
Contrast
(Display contrast)
{1}{4}{5}{1}–{6}: Level 1–6 <3> – –
Keytones
*7
{1}{6}{5}{1}: <On> {0}: Off ––
Auto Talk
*8
{2}{0}{0}{1}: On {0}: <Off>–17
TG6511-6521E(e).book Page 24 Monday, January 11, 2010 8:48 AM
To Next Page
Loading...
