Programming
23
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Programmable settings
You can customise the unit by programming the following features using the handset.
To access the features, there are 2 methods.
■ Scrolling through the display menus
1 8
2 Press {V} or {^} to select the desired main menu. s M
3 Press {V} or {^} to select the desired item from the next sub-menus. s M
4 Press {V} or {^} to select the desired setting. s M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {ic}.
■ Using the direct command code
1 8 s Enter the desired code.
Example: Press 8(1)1.
2 Select the desired setting. s M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {ic}.
Note:
L In the following table, < > indicates the default settings.
L In the following table, + indicates the reference page number.
L Display menu order and sub-menu may vary depending on your model.
Display the menu tree and direct command code table
Main menu: \ “Caller List”
Main menu: e “Answer System”
*1
Operation Code +
Viewing the caller list. #213 30
Sub-menu 1 Sub-menu 2 Settings Code +
Play New Msg.
(Msg.: message)
––#323 34
Play All Msg. ––#324 34
Erase All Msg.
*2
––#325 34
Greeting Start REC
*2
(Record greeting)
– #302 33
Play Greeting – #303 33
Default
*2
(Reset to pre-recorded
greeting)
– #304 33
TG6611-6621E(e).book Page 23 Tuesday, December 7, 2010 2:00 PM
To Next Page
Loading...
