Panasonic KX-TG6643B

Error messages
Display message Cause/solution
Base no power
o
r
No link. Re-connect
base AC adaptor.
or
No link.
R T
he handset has lost communication with the
base unit. Move closer to the base unit and try
again.
R Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
R The handset’s registration may have been
canceled. Re-register the handset (page 33).
R When “No link.” is displayed during a
power failure, place a handset on the base
unit to supply power to the base unit.
Busy
R T
he called unit is in use.
R Other units are in use and the system is busy.
Try again later.
R The handset you are using is too far from the
base unit. Move closer and try again.
Call phone company for
y
our access #
R Y
ou have not stored the voice mail access
number. Store the number (page 45).
Check tel line
R T
he supplied telephone line cord has not been
connected yet or not connected properly.
Check the connections (page 9).
Error!!
R R
ecording was too short. Try again.
Invalid
R T
here is no handset registered to the base
unit matching the handset number you
entered.
R The handset is not registered to the base unit.
Register the handset (page 33).
Requires subscription
t
o Caller ID.
R Y
ou must subscribe to a Caller ID service.
Once you receive caller information after
subscribing to a Caller ID service, this
message will not be displayed.
Use rechargeable
b
attery.
R A
wrong type of battery such as Alkaline or
Manganese was inserted. Use only the
rechargeable Ni-MH batteries noted on page 4,
6.
For assistance, please visit http://www.panasonic.com/help
51
Useful Information