Panasonic KX-TG6643B

Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R B
attery charge is low. Fully charge the batteries
(page 9).
I fully charged the batteries,
b
ut
–
still flashes,
– is displayed, or
–
the operating time
seems to be shorter.
R C
lean the battery ends (
, ) and the charge
c
ontacts with a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Making/answering calls, intercom
Problem Cause/solution
is displayed.
R T
he handset is too far from the base unit. Move
closer.
R The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit.
Register it (page 33).
Noise is heard, sound cuts
i
n and out.
R You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources
of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base
unit and the telephone line jack. Contact your DSL/
ADSL provider for details.
The handset does not ring. R T
he ringer volume is turned off. Adjust the ringer
volume (page 17).
R Silent mode is turned on. Turn it off (page 31).
The base unit does not ring. R T
he ringer volume is turned off. Adjust the ringer
volume (page 17).
I cannot make a call. R T
he dialing mode may be set incorrectly. Change
the setting (page 14).
R The handset is too far from the base unit. Move
closer and try again.
I cannot make long
d
istance calls.
R Make sure that you have long distance service.
For assistance, please visit http://www.panasonic.com/help
53
Useful Information