Panasonic KX-TG6671C

Making calls
Using the base unit
1 Dial the phone number.
R To correct a digit, press MCLEARN.
2 Lift the corded handset.
3 When you finish talking, place the corded
handset on the cradle.
Note:
R You can also dial the phone number after lifting
the corded handset.
Using the speakerphone
1 During a conversation with the corded
handset, press M N to turn on the
speakerphone.
R You can place the corded handset on the
cradle.
R Speak into the base unit microphone.
R Speak alternately with the other party.
2 When you finish talking, press M N.
Note:
R For best performance, use the speakerphone in
a quiet environment.
R To switch to the receiver, lift the corded handset.
Making a call using the redial list
The last 10 phone numbers dialed are stored in
the redial list (each 48 digits max.).
1 MREDIALN
2 MbN: Select the desired phone number.
3 Lift the corded handset.
Erasing a number in the redial list
1 MREDIALN
2 MbN: Select the desired phone number. a
MERASEN (soft key)
3 MbN: “Yes” a MSELECTN
4 MnN (EXIT)
Using the handset
1 Lift the handset and dial the phone number.
R To correct a digit, press MCLEARN.
2 Press M
N or MCALLN.
3 When you finish talking, press MOFFN or place
the handset on the charger.
Using the speakerphone
1 Dial the phone number and press M N.
R Speak alternately with the other party.
2 When you finish talking, press MOFFN.
Note:
R For best performance, use the speakerphone in
a quiet environment.
R To switch back to the receiver, press
M N/M N.
Making a call using the redial list
The last 5 phone numbers dialed are stored in the
redial list (each 48 digits max.).
1 MREDIALN or MEN REDIAL
R If there is a new message in the Voice Mail
or answering system, MREDIALN is not
displayed.
2 MbN: Select the desired phone number.
3 M N
Erasing a number in the redial list
1 MREDIALN or MEN REDIAL
2 MbN: Select the desired phone number. a
MERASEN
3 MbN: “Yes” a MSELECTN
4 MOFFN
Adjusting the receiver or speaker
volume
Base unit / Handset
Press MDN or MCN repeatedly while talking.
Pause (for PBX/long distance service
users)
A pause is sometimes required when making calls
using a PBX or long distance service. When
storing a calling card access number and/or PIN in
the phonebook, a pause is also needed
(page 19).
Example: If you need to dial the line access
number “9” when making outside calls with a PBX:
13
Making/Answering Calls