Error messages
Display message Cause/solution
Access # to VM service
is not stored
R You have not stored the Voice Mail access number. Store the
number (page 37).
Base no power
or
No link. Re-connect
base AC adaptor.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset’s registration may have been cancelled. Re-register
the handset (page 27).
Busy
R The called unit is in use.
R Other units are in use and the system is busy. Try again later.
R The handset you are using is too far from the base unit. Move
closer and try again.
Check tel line
R The supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
Error!!
R Recording was too short. Try again.
Invalid
R There is no handset registered to the base unit matching the
handset number you entered.
R The handset is not registered to the base unit. Register the
handset (page 27).
Requires subscription
to Caller ID.
R You must subscribe to a Call Display service. Once you receive
caller information after subscribing to a Call Display service, this
message will not be displayed.
Use rechargeable
battery.
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4,5.
42
Useful Information