R P
ress any dial key, M
N,
or M
N
to stop
the sound but keep the snooze function
activated.
R If you want to make an outside call when
the snooze function is activated, please
stop the snooze function before making the
call.
Night mode
N
ight mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set for each handset.
Important:
R Set the date and time beforehand
(page 15).
R We recommend turning the base unit ringer
off (page 26) in addition to turning the night
mode on. (KX-TG6821 series: page 3)
R If you have set the alarm, the alarm sounds
even if the night mode is turned on.
Turning night mode on/off
1 M N#238
2 MbN:
Select the desired setting. a MOKN
R If you select “Off”, press MeN to
exit.
3 Enter the desired hour and minute you
wish to start this feature. a MOKN
R You can select 24-hour or 12-hour
clock format (“AM” or “PM”) by
pressing *.
4 Enter the desired hour and minute you
wish to end this feature. a MOKN
5 MeN
R When the night mode is set,
is
d
isplayed.
Changing the start and end time
1 M N#237
2 C
ontinue from step 3, “Turning night
mode on/off”, page 30.
Setting the ring delay
T
his setting allows the handset to ring during
night mode if the caller waits long enough.
After the selected amount of time passes, the
handset rings. If you select “No Ringing”,
the handset never rings during night mode.
1 M
N#239
2 MbN:
Select the desired setting. a MOKN
a MeN
Note:
R When the answering system answers the
call, this feature does not work.
(KX-TG6821 series: page 3)
Changing the handset name
E
ach handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 M
N#104
2 E
nter the desired name (max. 10
characters; page 45).
R If not required, go to step 3.
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times
5 MeN
Incoming call barring (Caller ID
s
ubscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call.
30
Programming
To Next Page
Loading...
