Problem Cause/solution
I cannot connect my
he
adset to the base unit.
R Confirm that your headset is turned on.
R If your headset is already connected to another
Bluetooth device such as your cellular phone,
disconnect the headset from your cellular phone,
then perform the connecting procedure from the
base unit.
R If someone is using a cellular line, you cannot
connect the headset. There can be only one active
Bluetooth connection at a time.
R The headset has not been registered to the base
unit. Register the headset (page 58).
Some headset enhanced
fe
atures are not available.
R The base unit does not support enhanced features
such as Last number redial or Call reject.
An error tone is heard
wh
en I try to program the
Bluetooth feature.
R The bluetooth feature cannot be accessed
immediately after connecting the AC adaptor to
the base unit. Wait a few seconds and try again.
R The headset has not connected to the base unit
yet, even though you performed the connecting
procedure setting. Wait a few seconds and try
again.
Answering system
Problem Cause/solution
The unit does not record
n
e
w messages.
R The answering system is turned off. Turn it on
(page 60).
R The answering system does not answer or record
calls from cellular lines.
R The message memory is full. Erase unnecessary
messages (page 62).
R The recording time is set to “Greeting only”.
Change the setting (page 65).
R If you subscribe to a voice mail service, messages
are recorded by your service provider/telephone
company, not your telephone. Change the unit’s
number of rings setting or contact your service
provider/telephone company (page 65).
R The answering system will not answer incoming
calls while:
– the base unit or 2 or more handsets are on a
cellular call or an intercom call.
– a headset is in use.
Caller information is recorded in the caller list.
For assistance, please visit http://www.panasonic.com/help
81
Useful Information
To Next Page
Loading...
