Panasonic KX-TG8041RUM

18
KX-TG8041RU/KX-TGA800RU
Frequently Used Items (Base Unit)
ex.)
Note:
(*1) When you enter the address or New Data, please refer to the table below.
(*2)
Items Address Default Data New Data Remarks
C-ID (FSK) sensitivity 04 D6 00 01 (6 dB up) 02 (12 dB up) When hex changes from “00” to “01” or “02”,
gain increases by 6 dB or 12 dB.
C-ID (DTMF) sensitivity 04 E4 50 60 (6 dB up) 70 (12 dB up) When hex changes from “50” to “60” or “70”,
gain increases by 6 dB or 12 dB.
Frequency 00 02/00 01 03/50 - - Use these items in a READ-ONLY mode to
confirm the contents. Careless rewriting may
cause serious damage to the computer system.
ID 00 10~00 14 Given value - -
Bell length 01 F5 32 (5 sec) (*2) 1E (3 sec) 14 (2 sec) This is time until bell stops ringing.
(Unit: 100 ms)
PULSE Dial speed
(10 PPS -> 20 PPS)
03 B2 28 (40 msec)
(*2)
14 (20msec) - This is pulse make time. (Unit:1 ms)
03 B3 3C (60 msec)
(*2)
1E (30msec) - This is pulse break time. (Unit:1 ms)
01 E4 57 (870 msec)
(*2)
2C (440 msec) - This is inter-digit time in pulse mode.
(Unit:10 ms)
Desired Number (hex) Input Keys Desired Number (hex) Input Keys
00 A[R] + 0
11 B[R] + 1
.. C[R] + 2
.. D[R] + 3
.. E[R] + 4
99 F[R] + 5
Bell length 32(hex) = 50(dec) → 50 × 100 msec = 5000 msec (5 sec)
PULSE Dial speed
(10PPS -> 20PPS)
28 (hex) = 40 (dec) → 40 × 1 msec = 40 msec
3C (hex) = 60 (dec) → 60 × 1 msec = 60 msec
57 (hex) = 87 (dec) → 87 × 10 msec = 870 msec