Panasonic KX-TG8041RUM

39
KX-TG8041RU/KX-TGA800RU
9.2.2. Check Point (Charger Unit)
Note:
After the measuring, suck up the solder of TP.
The connection of adjustment equipment is as shown in Adjustment Standard (Charger Unit) (P.52).
(O)* Timing Confirmation -
ANTI_TP
Follow steps 1 to 6 of (J).
7.Confirm that the Timing accuracy is
• ± 5.0 ppm (When adjust the frequency of CLK in item (G)).
• ± 15 ppm (When do not adjust the frequency of CLK in item (A)).
IC7, L104,
C101, C106,
C102, C109,
R65, R66, DA1,
R802~R807,
C837, C826,
C822, C820,
C832, C833,
C63, Q401,
C402, C105,
C110, C65,
IC801, D801,
D802,
C801~C804,
C808~C814,
L802~L804,
C819, C834,
C825
(P)* Power RAMP Confirma-
tion
- Follow steps 1 to 6 of (J).
7.Confirm that Power RAMP is matching.
IC7, L104,
C101, C106,
C102, C109,
R65, R66, DA1,
R802~R807,
C837, C826,
C822, C820,
C832, C833,
C63, Q401,
C402, C105,
C110, C65,
IC801, D801,
D802,
C801~C804,
C808~C814,
L802~L804,
C819, C834,
C825
(Q) Audio Check - 1. Link with Handset.
2. Input -45dBm/1kHz to MIC of Handset.
Measure the Level at Line I/F and distortion level.
3. Confirm that the level is -10 dBm ± 2 dBm and that the distortion level is < 5%
at TEL Line (600 Ω Load).
4. Input -20 dBm/1 kHz to Line I/F.
Measure the level at Receiver of Handset and distortion level
(*Receive volume set to second position from minimum).
5. Confirm that the level is -21 dBm ± 2 dBm and that the distortion level is < 5%
at Receiver (Volume Middle, 150 Ω Load).
IC7, SA1, L1,
L2, D3, Q3, Q4,
R14, R15, R16,
R17
(R) Charging Check - 1. Connect Charge Contact 12 Ω/2 W resistor between charge+ and charge-.
2. Measure and confirm voltage across the resistor is 2.75 V ± 0.3 V.
R56, R57, D22,
D23
(S)* TAM Operation Confir-
mation
- 1. TAM Confirmation (Execute the command "sendchar VPI").
2. Confirm the returned Value (Value is "DAS7RN 02").
IC7, IC421,
R424~R429,
C421, C422,
Q421
Items Check
Point
Procedure Check or
Replace Parts
(A) Charging Check - 1. Connect Charge Contact 12 Ω/2 W resistor between charge+ and charge-.
2. Measure and confirm voltage across the resistor is 2.75 V ± 0.3 V.
R1, F1
Items Check
Point
Procedure Check or
Replace Parts