Panasonic KX-TG8105RU - Page 22

22
KX-TG8105RU/KX-TG8106RU/KX-TGA810RU
Frequently Used Items (Base Unit)
ex.)
Note:
(*1) Refer to Registering a Handset to a Base Unit (P.19).
(*2) When you enter the address or New Data, please refer to the table below.
Items (*3) Address Default Data New Data Remarks
C-ID (FSK) sensitivity 04 72 00 01 (6dB up) 02 (12dB up) When hex changes from “00” to “01” or “02”, gain
increases by 6dB or 12dB.
C-ID (DTMF) sensitivity 04 80 50 60 (6dB up) 70 (12dB up) When hex changes from “50” to “60” or “70”, gain
increases by 6dB or 12dB.
SMS (FSK) receiving
sensitivity
04 72 00 01 (6dB up) 02 (12dB up) When hex changes from “00” to “01” or “02”, gain
increases by 6dB or 12dB.
SMS (FSK) sending
level
04 8C/04 8B 0F/B0 19/20 (6dB up) 32/40 (12dB up) When hex changes from “00 0B” to “00 16” or “00
2C”, gain increases by 6dB or 12dB.
Frequency 00 01 75 - - Use these items in a READ-ONLY mode to con-
firm the contents. Careless rewriting may cause
serious damage to the computer system.
ID 00 10~00 14 Given value - -
Bell length 01 F6 32 (5sec) (*4) 1E (3sec) 14 (2sec) This is time until bell stops ringing. (Unit: 100ms)
PULSE Dial speed
(10PPS -> 20PPS)
03 5F 28 (40msec) (*4) 14 (20msec) - This is pulse make time. (Unit:1ms)
03 60 3C (60msec) (*4) 1E (30msec) - This is pulse break time. (Unit:1ms)
01 E4 57 (870msec) (*4) 2C (440msec) - This is inter-digit time in pulse mode. (Unit:10ms)
Desired Number (hex.) Input Keys Desired Number (hex.) Input Keys
00 A[R] + 0
11 B[R] + 1
.. C[R] + 2
.. D[R] + 3
.. E[R] + 4
99 F[R] + 5