Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1 MM
ENUN#138
2 MbN: Select the desired setting. a MOKN
a M
N
Registering the DECT repeater
(
KX-A405/KX-A406) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Press and hold M
N
for about 5 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the
indicator and indicator light
g
reen.
3 Base unit:
To exit the registration mode, press M
N.
34
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Programming
To Next Page
Loading...
