Panasonic KX-TGE823E - User Manual

Questions and Answers

A
Alexander ChangSep 23, 2025
What to do if liquid or other form of moisture has entered the handset/base unit of my Panasonic KX-TGE823E?
- C
  Calvin SparksSep 23, 2025
  Disconnect the AC adaptor and telephone line cord from the base unit. Remove the batteries from the handset and leave to dry for at least 3 days. After the handset/base unit are completely dry, reconnect the AC adaptor and telephone line cord. Insert the batteries and charge fully before use. If the unit does not work properly, contact an authorised service centre.
S
Sheila CastilloAug 23, 2025
Why does my Panasonic KX-TGE823E handset beep and/or flash?
- H
  hnealAug 23, 2025
  This usually indicates that the battery charge is low. Fully charge the batteries.
I
Ivan AustinAug 25, 2025
What to do if the handset does not ring on my Panasonic Answering Machine?
- P
  Pamela ThomasAug 26, 2025
  First, check if the ringer volume is turned off and adjust it if necessary. Also, ensure that 'do not disturb' mode is turned off. If the handset is registered to multiple base units, the handset may not be able to make or receive calls or communicate with the base unit when the following conditions are met: Eco mode is set to “Eco Plus”. Base unit selection is set to “Auto”. In this case, place the handset near the base unit, and change the setting to “Eco” or “Off”. Repeat for each base unit.
H
Hayley GillAug 27, 2025
Why is caller information not displayed on my Panasonic KX-TGE823E?
- S
  Shannon MillerAug 27, 2025
  You must subscribe to a Caller ID service. If you are already subscribed, and your unit is connected to additional telephone equipment, remove the equipment and plug the unit directly into the wall jack. If you use a DSL/ADSL service, connect a DSL/ADSL filter between the base unit and the telephone line jack. Also, other telephone equipment may be interfering with this unit, so disconnect the other equipment and try again.
A
Amanda JamesAug 27, 2025
What to do if my Panasonic Answering Machine handset does not turn on?
- R
  Ronald FitzgeraldAug 27, 2025
  Place the handset on the base unit or charger to turn on the handset.
C
cameron55Sep 17, 2025
Why does the Panasonic Answering Machine unit not emit the specified number of rings?
- L
  lisaboyerSep 18, 2025
  If the first ring is turned off, the number of rings decreases by 1 from the specified number of rings.
N
Nathaniel MooreSep 14, 2025
Why can't I activate eco mode on my Panasonic KX-TGE823E Answering Machine?
- N
  Nathan ParsonsSep 14, 2025
  You cannot set eco mode when you set the repeater mode “On”. If required, set the repeater mode to “Off”.
T
Theresa Bridges DVMSep 15, 2025
Why can't I use the intercom feature on my Panasonic KX-TGE823E Answering Machine?
- M
  maloneclaireSep 15, 2025
  This feature is available between the handsets. Although the handset displays “Intercom”, or “Auto Intercom”, these features are not available for single handset models.
M
Monica ArmstrongSep 6, 2025
What to do if my Panasonic KX-TGE823E Answering Machine unit does not work?
- R
  Robert GoodmanSep 6, 2025
  Make sure the batteries are installed correctly. Fully charge the batteries. Check the connections. Unplug the base unit’s AC adaptor to reset the unit and turn off the handset. Reconnect the adaptor, turn on the handset and try again. If the handset has not been registered to the base unit, register the handset.
T
tiffany78Sep 3, 2025
Why is there noise heard, and sound cuts in and out on my Panasonic KX-TGE823E Answering Machine?
- J
  Joseph AguirreSep 3, 2025
  This could be due to using the handset or base unit in an area with high electrical interference. Try re-positioning the base unit and using the handset away from sources of interference. Also, try moving closer to the base unit. If you use a DSL/ADSL service, consider connecting a DSL/ADSL filter between the base unit and the telephone line jack.

Summary

Getting Started

Setting Up

Step-by-step instructions for initial product setup, connections, and battery installation.

Controls

Display Icons

Date and Time

Eco Mode Setting

Making and Answering Calls

Making Calls

Procedures for initiating phone calls using the handset, including speakerphone.

Answering Calls

How to receive and end incoming phone calls, including any-key answer.

Useful Features During a Call

Intercom

Call Management Features

Nuisance Call Block

Methods for blocking unwanted incoming calls manually or by storing numbers.

Automated Call Block

Settings and features for automatically blocking certain calls like telemarketing.

Phonebook

Speed Dial

Programming and Customization

Menu List

Ringer Setup

Do Not Disturb Mode

Baby Monitor

Caller ID and Answering System

Caller ID Service

Answering System

Functions for answering calls, recording messages, and playing greetings.

Remote Operation

How to access answering system functions remotely via phone.

Useful Information and Support

Troubleshooting

Solutions for common problems and issues encountered with the device.

Panasonic KX-TGE823E Specifications

General

Number of Handsets	3
Caller ID	Yes
Range (Outdoors)	300 meters
Speakerphone	Yes
Display	LCD
GAP compatible	Yes
Frequency	1.9 GHz
Remote Access	Yes
Call Waiting Caller ID	Yes
Power Source	AC Adapter
Battery Backup	Yes
Phonebook Capacity	100 names and numbers