Character entry
T
he dial keys are used to enter characters and numbers. Each dial key has multiple characters assigned
to it. The characters that can be entered depend on the character entry mode (page 49).
– Handset: Press MFN or MEN to move the cursor left or right.
– Base unit: Press M
N
or M
N
to move the cursor left or right.
– Press dial keys to enter characters and numbers.
– Press MCLEARN to erase the character or number highlighted by the cursor. Press and hold MCLEARN
to erase all characters or numbers.
– Press * (Aaa) to switch between uppercase and lowercase.
– To enter another character located on the same dial key, press MEN on the handset or M
N
on the
base unit to move the cursor to the next space, then press the appropriate dial key.
– If you do not press any dial key within 2 seconds after entering a character, the character is fixed and
the cursor moves to the next space.
Character entry modes
T
he available character entry modes are Alphabet (ABC), Numeric (0-9), Greek (
), Extended 1
( ), Extended 2 ( ), and Cyrillic ( ). When in these entry modes except Numeric, you can select
w
hich character is entered by pressing a dial key repeatedly.
When the unit displays the character entry screen:
Handset: MECON a MbN: Select a character entry mode. a MOKN
Base unit: M
N a MbN:
Select a character entry mode. a MOKN
Note:
R
in the following tables represents a single space.
A
lphabet character table (ABC)
To Next Page
Loading...
