Baby monitor sensitivity
Y
ou can adjust the sensitivity of the baby monitor.
Increase or decrease the sensitivity to adjust the
sound level needed to trigger the baby monitor
feature.
R This feature cannot be set during a monitoring
call.
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “Sensitivity level” a MSELECTN
3 MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering the baby monitor
Handset / Base unit
n W
hen monitoring with a unit:
Handset: Press MTALK/ZN to answer a call.
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will respond calls
automatically when the auto intercom feature
is set to “On” (page 26).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press MTALK/ZN.
– To answer the call with the base unit, press
MZN 3 times.
*1
*1 If MMUTEN is pressed, press MZN 2 times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature by
pressing #0.
Note:
R The unit disconnects the call automatically
after 2 minutes.
Other programming
Changing the handset name
T
he default handset name is “Handset 1” to
“Handset 6”. You can customize the name of
each handset (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between handsets.
To display the handset name in standby mode,
turn on the handset name display feature
(page 48).
Handset
1 MM
ENUN#104
2 Enter the desired name (10 characters max.).
a MSAVEN a MOFFN
Displaying the handset name
Y
ou can select whether or not the handset name
is displayed in standby mode. The default setting
is “Off”.
Handset
1 MM
ENUN#105
2 MbN: Select the desired setting. a MSAVEN
a MOFFN
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R See page 4 for information on the available
model.
Registering a h
andset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1 Handset:
MMENUN#130
48
For assistance, please visit http://shop.panasonic.com/support
Programming
To Next Page
Loading...
