Display message Cause/solution
Check tel line
R T
he supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 10).
Checking
R T
he automated call block function is in operation. Try again later.
Error!!
R R
ecording was too short. Try again.
R Although the unit tried to pair with the headphone, the pairing has
been failed.
– Make sure that the headphone is not connected to other
Bluetooth devices.
– The headphone is turned off or the battery is low. Turn it on or
fully charge the headphone.
– The Bluetooth headphone is out of range. Move closer and try
again.
– The Bluetooth headphone is in the cradle. Lift the headphone.
– The same headphone is already paired.
Memory full
R T
he recording memory is full. Erase unwanted recordings
(page 53).
Invalid
R T
here is no handset registered to the base unit matching the
handset number you entered.
R The handset is not registered to the base unit. Register the
handset (page 48).
Requires
s
ubscription
to Caller ID.
R Y
ou must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Use rechargeable
b
attery.
R A
wrong type of battery such as alkaline or manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 7.
Failed.
C
heck power at
headphone.
R Although the unit tried to connect to the headphone, the
connection has failed.
– Make sure that the headphone is not connected to other
Bluetooth devices.
– The headphone is turned off or the battery is low. Turn it on or
fully charge the headphone.
– The Bluetooth headphone is out of range. Move closer and try
again.
– The Bluetooth headphone is in the cradle. Lift the headphone.
Check
B
luetooth
connection.
R A
lthough the unit tried to connect to the headphone, the
connection has failed.
– Make sure that the headphone is not connected to other
Bluetooth devices.
Already stored. R T
he same headphone is already paired.
R The same information is already stored in the phonebook.
Troubleshooting
I
f you still have difficulties after following the instructions in this section, disconnect the base unit’s AC
adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then
insert them into the handset again.
For assistance, please visit http://shop.panasonic.com/support
61
Useful Information
To Next Page
Loading...
