If the base unit batteries for power backup are installed, remove the batteries from the base unit, and
t
hen insert them into the base unit again.
General use
Problem Cause/solution
The handset does not turn on
e
ven after installing charged
batteries.
R Place the handset on the charger to turn on the handset.
The unit does not work. R M
ake sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 11).
R Check the connections (page 10).
R Unplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset has not been registered to the base unit. Register
the handset (page 48).
I cannot hear a dial tone. R T
he base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and connect
the line to a known working telephone. If the working telephone
operates properly, contact our service personnel to have the
unit repaired. If the working telephone does not operate
properly, contact your phone service provider.
The base unit beeps. R N
ew messages have been recorded. Listen to the new
messages (page 53).
Error sound is heard when I press
s
ome keys on base unit.
R Automated call block is being screened. Try again later.
The unit does not emit the
s
pecified number of rings.
R The number of rings decreases by 1 from the specified number
of rings in below situations:
– the first ring is turned off (“No”) (page 28).
– answer by voice command is set to “On” (page 25).
The unit does not work during a
p
ower failure.
R You can insert 2 AAA (R03) batteries (not supplied) into the
base unit that will power the unit temporarily in the event of a
power failure (page 11).
R The base unit display is blank if the saving mode is “On”
(page 12).
Menu list
Problem Cause/solution
The display is in a language I
c
annot read.
R Change the display language (page 15).
I cannot register a handset to a
b
ase unit.
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 49).
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R B
attery charge is low. Fully charge the batteries (page 11).
62
For assistance, please visit http://shop.panasonic.com/support
Useful Information
To Next Page
Loading...
