:
Programming using the Base Unit (KX-TGP550 only)
35
Document Version 2010-08
*1 If you program these settings using the base unit, you do not need to program the same item using a
handset.
Programming using the direct commands
1
{MENU} (middle soft key) i {#}
2 Enter the desired feature code.
3 {V}/{^}: Select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT}.
Note:
L In the following table, < > indicates the default settings and ( ) indicates lines you need to select for the
settings.
*1 If you program these settings using the base unit, you do not need to program the same item using a
handset.
Initial settings
"
Set Date/Time
*1
–39
Caller Barred
*1
–38
LCD Contrast ––
Base Unit PIN
*1
–39
Software version
*1
–39
Phonebook
C
––24
Caller List
W
––43
Feature Feature
code
Setting code System
setting
*1
Page
Base Unit PIN {1}{3}{2} – r 39
Caller Barred {2}{1}{7} – r 38
DHCP
*2
{5}{0}{0}{1}: <On>
{0}: Off
r –
Embedded Web {5}{3}{4}{1}: On
{0}: <Off>
–41
Interrupt tone
*3
{2}{0}{1}{1}: <On>
{0}: Off
– 19, 47
IP Settings
*2
{5}{0}{1} – r –
LCD Contrast
(Display contrast)
{1}{4}{5}{1} – {6}: Level 1–6 <3> – –
Phonebook {2}{8}{0} ––24
Ringtone {1}{6}{1} (Line 1: 8
max.)
{1} – {9}:
Ringtone <1>–9
––
Ringer Volume
*4
{1}{6}{0}{1} – {3}: Level 1–<3>
{0}: Off
–18
Set Date/Time {1}{0}{1} – r 39
Software version {1}{5}{6} – r 39
Main menu Sub-menu 1 Sub-menu 2 Page
To Next Page
Loading...
