Intercom Features
47
Document Version 2010-08
Note:
L If the other handset user does not answer the
call within 1 minute, the call rings at your
handset again.
Answering a transferred call
Press {C} to answer the page.
Note:
L After the paging party disconnects, you can talk
to the outside caller.
Intercom features between
the handset and base unit
(KX-TGP550 only)
Intercom
Intercom calls can be made between the handset
and base unit.
Note:
L If you receive an outside call while talking on the
intercom, you hear interrupt tones (page 29, 35).
– To answer the call with the handset, press
{OFF}, then press {C}.
– To answer the call with the base unit, place
the corded handset on the cradle, then lift it
again. If the speakerphone is used, press
{SP-PHONE} 2 times.
L When paging the handset, the paged handset
beeps for 1 minute.
Making an intercom call
1 {MENU} (centre of joystick)
2 {V}/{^}: “Intercom” i {SELECT}
3 {V}/{^}: Select the desired unit. i {CALL}
L To stop paging, press { OFF}.
4 When you finish talking, press {OFF}.
1 Press {j} – {k} or {ALL}.
L Lift the corded handset if needed.
L To stop paging, press the same button.
2 When you finish talking, press {SP-PHONE}
or place the corded handset on the cradle.
Answering an intercom call
1 Press {C} to answer the page.
2 When you finish talking, press {OFF}.
1 Lift the corded handset or press {SP-PHONE}
to answer the page.
2 When you finish talking, place the corded
handset on the cradle or press {SP-PHONE}.
Answering an intercom call using auto
intercom
Before using the auto intercom, turn auto intercom
on (page 46).
1 When you are paged by the base unit, speak
into the microphone.
L To switch to the receiver, press {C}.
2 To end the intercom, press { OFF}.
Monitoring audio in a room using auto
intercom
You can listen to the sound in a room where the
handset is located using the auto intercom.
Important:
L Before using this feature, set auto intercom on
the destination handset to “On (Ringer
Off)” to allow access by the base unit.
1 Call the destination handset (page 47).
L You can listen to the audio.
2 To mute your sound output, press { MUTE} if
necessary.
3 To stop monitoring, press {SP-PHONE} or
place the corded handset on the cradle.
Y Handset
: Base unit
Y Handset
: Base unit
Y Handset
: Base unit
To Next Page
Loading...
