For assistance, please call: 1-800-211-PANA(7262)
Advanced Operation
15
To store in a LOWER memory location
Make sure that a call is not put on hold.
1
Press (PROGRAM).
≥The MUTE indicator flashes.
2
Enter a phone number, up to 22 digits.
≥If you enter a wrong number, press (PROGRAM) and start again from
step 1.
3
Press (AUTO/LOWER).
4
Press one of the one-touch auto dial buttons.
≥A long beep sounds.
≥The MUTE indicator light goes out.
≥The unit will return to the standby mode.
≥If 3 beeps sound, the number entered in step 2 may be over 22 digits. Lift
the handset and place it on the cradle to return to the standby mode, and
start again from step 1.
≥If a pause is required for dialing, press (PAUSE) where needed. Pressing
(PAUSE) counts as one digit (p. 17).
To erase a stored number
1
Press (PROGRAM).
≥The MUTE indicator flashes.
2
If the phone number is in an UPPER memory location, press the
one-touch auto dial button for the phone number to be erased.
OR
If the phone number is in a LOWER memory location, press
(AUTO/LOWER), then press the one-touch auto dial button for the
phone number to be erased.
≥A long beep sounds.
≥The MUTE indicator light goes out.
≥The unit will return to the standby mode.
≥When using the Dial Lock (p. 20) or Call Restriction feature (p. 21), you cannot
erase a phone number in the EMERGENCY button.
“
To Next Page
Loading...
