2.1 Mailbox Settings
Programming Guide 37
Subscriber's Guide References
5.4 Interview Mailbox
All Calls Transfer to Mailbox
If this parameter is set to "Yes", all calls routed to the extension are automatically forwarded to the
extension's mailbox without ringing the telephone. Forwarding is accomplished through the
Automated Attendant service. Callers are permitted to leave a message.
Note
• When this feature has been set to "Yes", the subscriber's extension does not necessarily
need to exist as a phone extension of the PBX.
Value Range
No, Yes
Feature Guide References
2.3.3 Automated Attendant
Call Transfer Sequence
Specifies how the VPS transfers a call to an extension for each mailbox (Personal Transfer
Sequence). To specify the sequence, use the dial codes and special codes:
Note
• When "None" is selected, the VPS follows the "Extension Transfer Sequence"
preprogrammed for the VPS in the "System Parameters→Parameters→PBX
Parameters→PBX Environment".
• This sequence has higher priority than "Alternate Extension Transfer Sequence" in 2.5.4
Parameters.
Value Range
Max. 16 characters consisting of 0–9, , # and special codes:
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
1–9, 0, , #: Dial Code
Programming Guide References
2.5.4 Parameters
To Next Page
Loading...
