Panasonic KX-TVS300 - Wait for Caller ID (WCID)

SYSTEM MAINTENANCE AND TROUBLESHOOTING
190 Installation Manual
Sample display:
Note
The maximum number of ports depends on the VPS model.
WARNING
"PUTD" is a command originally used when troubleshooting. Do not use this command
for any other purpose. Do not disconnect the RS-232C connection while the "PUTD"
command is enabled. This could cause data overflow.
7.2.20 Wait for Caller ID (WCID)
Use the WCID command to specify the length of time (in seconds) the VPS must wait for the
Caller ID after the VPS has received the incoming call from the PBX.
If Caller ID is not needed at all, set the waiting time to "0" to accelerate the VPS response to
incoming calls.
Type WCID, then Press RETURN.
$ PUTD
Target Port for Debug : * * * * * * * * * * * * * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$
[1] DTMF:3
[1] DTMF:8
[1] A.Attend
[1] DTMF:#
[1] DTMF:6
[1] Voice Mail
[1] DTMF:1
[1] DTMF:0
[1] DTMF:1
[1] NonSub Svc
[1] * * *
[1] DTMF:#
[1] DTMF:9
[1] Thank you
$ WCID
WAIT TIME FOR CALLER ID (5 sec) [0-60 sec] : = 0
$