Installation and Setup
13
– Bluetooth
®
headsets (KX-UTG300 only)
For up-to-date information about headsets that have been tested
with this unit, refer to the following web site:
http://www.panasonic.com/sip
When connecting the Ethernet cable
• Connect the Ethernet cable as shown in the following illustration.
•
Ethernet cableEthernet cable
Incorrect Correct
Use the included Ethernet cable.
When connecting to a switching hub
• If PoE is available, an AC adaptor is not needed. An AC adaptor must
be used when the KX-UTA336 Add-on key module is installed to the
KX-UTG300.
• This unit complies with the PoE Class 2 standard.
When connecting a PC
• Only a PC can be connected to the PC port. Other SIP phones, or
network devices such as routers or switching hubs, cannot be connected.
• The PC port does not support PoE for connected devices.
When connecting cables and the AC adaptor
• Ensure that the Ethernet cable and the AC adaptor cord are clamped
to prevent damage to the connectors.
When registering a Bluetooth headset (KX-UTG300 only)
• One Bluetooth headset can be registered to this unit. For details, see
the Operating Instructions.
To Next Page
Loading...
