Panasonic LP-V15U - Page 110

110
⿎
Logo le : CDF
Sets the logo le.
• Setting / Readout data of logo marking function
STX CDF
Sub
command
[Log No.] [Log le name]
Variable length
(Check sum) Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of logo marking function
STX CDF R
[Logo No.]
2-byte
(Check sum) Delimiter
Name Data length [byte] Description Remarks
Logo No. 2 “00”–“15”
Logo le name Variable length
The long le name can be
specied. Except the extended
characters, entry of up to 10 shift-
JIS characters or 20 ASCII code
characters is recommended.
The logo le name corresponding to the
specied number is indicated.
The logo le setting will be deleted when no
le name is specied in this command.
• For VEC le, the extension can be
omitted (in this case, the response has
an extension.)
When the le name is “ABCD.VEC”:
“ABCD” or “ABCD.VEC”
• For a DXF le, an extension is required.
When the le name is “ABCD.DXF”:
“ABCD.DXF”.
Reference
• In the case of specifying logo le in VEC format, apply CDC command for setting logo condition, and in the case of
specifying logo le in DXF format, apply CDD command for setting logo condition.
• If readout data includes characters that cannot be expressed in ASCII code such as Katakana and Kanji (2-byte
character), these 2-byte characters are read out in shift-JIS code.
ME-LP400V-EX-6