Panasonic LP-V15U - Command List - Operation Control

74
3-6 Communication Command List
Category Name Code Function Page
Operation control
Command reception
permission
MKM Controls the reception permission (reception mode
ON/OFF) for setting and readout of communication
commands.
P.78
Laser pumping LSR Controls the laser pumping ON/OFF. P.79
Shutter SHT Controls the internal shutter opening/closing. P.79
Status request STS Requires the operation status of laser marker, such as
ready status and error occurrence status.
P.80
Marking status sending
permission
MST Enables automatic response of marking result (e.g.
normal end, and error occurrence, etc.) at the end of
marking.
P.81
Marking trigger MRK Inputs marking trigger (laser radiation startup trigger). P.82
Guide laser control GID Controls radiation of red guide laser for marking
position conrmation.
P.82
File
File change (No. specied) FNO Species the le No. to change the le. P.83
File change (Comment
specied)
FNN Species the le name (comment) to change the le. P.83
File overwriting registration FOR Overwrite and register the le under editing. P.83
File registration FRG Register the le under editing to the specied No. P.84
File name FNM Sets name (comment) of le under editing. P.84
Character input
Marking character string
(ASCII code specied)
MCS Sets the marking character string by ASCII code.
(For alphanumeric and symbols only)
P.85
Marking character string
(Shift-JIS code specied)
STR Sets the marking character string by shift-JIS code.
(For characters including KANA, KANJI and function
characters)
P.85
Serial data input SIN Sets the character string specied for “Serial Data
Function” to change characters for each marking.
P.87
Rank condition RKC Sets input conditions of “Rank Function” to switch
characters using I/O input.
P.89
Rank character string RKS Sets character string used for “Rank Function” to
switch characters using I/O input.
P.89
ME-LP400V-EX-6