Panasonic LP-V15U - Page 83

83
⿎
File change [No. specied] : FNO
Species the le No. to change the le.
• Change le No.
Read out the le of specied number.
STX FNO
Sub
command
[File No.]
4-byte
(Check sum) Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of le No.
STX FNO R (Check sum) Delimiter
Name Data length [byte] Description Remarks
File No. 4
“0000”–“2047”
“9999”: new le
The le number to be used and the le
number currently being used is indicated
at le No. change and readout of le No.
respectively.
⿎
File change [Comment specied] : FNN
Species the le name (comment) to change the le.
• Change le No.
Changes le No. according to the le name (comment).
STX FNN S
[File name]
Max. 20-byte
(Check sum) Delimiter
Name Data length [byte] Description Remarks
File name Max. 20
Specify the le name
with 10 or less characters
of shift-JIS code, or 20 or
less characters of ASCII
code.
Ex) When changing to a le name (comment) with
“ABCD”, set as follows:
• When specifying the le name in shift-JIS code:
82,60,82,61,82,62,82,63(HEX)
• When specifying the le name in ASCII code:
41,42,43,44(HEX)
Reference
• When two or more of the same le names exists, the le with the smaller no. is selected.
⿎
File overwriting registration : FOR
Overwrite and register the le under editing.
Overwriting is possible when the le number has been already determined.
• Overwriting of le
STX FOR S (Check sum) Delimiter
ME-LP400V-EX-6