• Microsoft product screen shot(s) reprinted with permission from Microsoft Corporation.
• Other names, company names, and product names printed
in
these instructions are
trademarks or registered trademarks of the companies concerned.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in
a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used
in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur
in
a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user
is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into
an
outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radiofTV technician for help.
FCC Caution:
To
assure continued compliance, follow the attached installation
instructions and use only shielded interface cables with ferrite core when
connecting to computer
or
peripheral devices.
Any changes
or
modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
Declaration of Conformity
Trade Name: Panasonic
Model No.: DMC-FS42
DMC-FS4
Responsible party: Panasonic Corporation of North America
One Panasonic
Way,
Secaucus, NJ 07094
Support Contact: Panasonic Consumer Electronics Company
1-800-211-PANA(7262)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
IFC~I
(ENG) VQT2B45 3
To Next Page
Loading...
Need help?
General
Weight and Dimensions
