Preparation
- 28 -
• The brightness of the pictures displayed on the LCD monitor is increased so some subjects
may appear differently from actuality on the LCD monitor. However, this does not affect the
recorded pictures.
• The LCD monitor automatically returns to normal brightness after 30 seconds when recording
in Power LCD mode. Press any button to make the LCD monitor bright again.
• If the screen is difficult to see because of light from the sun etc. shining on it, use your hand or
another object to block the light.
• The number of recordable pictures decreases in Auto Power LCD mode and Power LCD mode.
• The [PATTERN] setting is fixed to [ ] in the Intelligent auto mode.
[MONITOR] Adjust the brightness of the LCD monitor in 7 steps.
[LCD MODE]
These menu settings make it easier to see the LCD monitor when
you are in bright places.
[OFF]
„ [AUTO POWER LCD]:
The brightness is adjusted automatically depending on how bright
it is around the camera.
… [POWER LCD]:
The LCD monitor becomes brighter and easier to see even when
taking pictures outdoors.
[GUIDE LINE]
Set the pattern of the guide lines displayed when taking pictures.
You can also set whether or not to have the recording information
displayed when the guide lines are displayed. (P50)
[REC. INFO.]:
[OFF]/[ON]
[PATTERN]:
[]/[]
To Next Page
Loading...
