- 61 -
Advanced (Recording pictures)
In this mode, up to 3 pictures in black & white, standard, or sepia in the selected modes
are automatically recorded each time the shutter button is pressed.
Press 3 [È] until [AUTO BRACKET] appears, press
[DISPLAY].
• It is switched between auto bracket and colour bracket every time
[DISPLAY] is pressed.
Press 2/1 to select the mode.
Press [MENU/SET] to finish.
• You can also press the shutter button halfway to finish.
Note
•
When setting auto bracket, [ ] appears on the screen, and when setting colour bracket, [ ]
appears on the screen.
• When taking pictures using auto bracket after setting the exposure compensation range, the
pictures taken are based on the selected exposure compensation range. When the exposure is
compensated, the exposure compensation value appears on the lower left of the screen.
• The auto bracket setting is cancelled if you turn the camera off or [POWER SAVE] is activated.
• When auto bracket/colour bracket is set, the auto review function is activated regardless of the
auto review setting. (The picture is not enlarged.) You cannot set the auto review function in the
[SETUP] menu.
• The exposure may not be compensated with auto bracket depending on the brightness of the
subject.
• [Œ] is set for the flash when auto bracket/colour bracket is set.
• Burst is cancelled when auto bracket/colour bracket is set.
• The one set last will take precedence. (auto bracket and colour bracket cannot be set
simultaneously.)
• Auto bracket/colour bracket cannot be used in following cases:
– When [QUALITY] is set to [ ] or [ ]
– When the shutter speed becomes longer than 1 second with manual exposure
Colour Bracket
[OFF]:
[MODE1]:
[B/W]/[STANDARD]
[MODE2]:
[STANDARD]/[SEPIA]
[MODE3]: [B/W]/[STANDARD]/[SEPIA]
To Next Page
Loading...
Need help?
General
