133
VQT3A48
Recording
• Refer to P95 for details.
•
Set to [ON] to display the [EXPO.METER] when correcting exposure,
performing programme shift, setting aperture, and setting shutter speed.
• Unsuitable areas of the range are displayed in red.
• When [EXPO.METER] is not displayed, switch the display information
for LCD monitor/viewfinder by pressing [DISPLAY]. (P64)
• The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
Setting items for each [REC] Mode
•
You cannot switch between LCD monitor and viewfinder by pressing [LVF/LCD] when it is set to
[SWITCH BY PRESSING THE LVF/LCD BUTTON].
•
[EXPO. SETTINGS] is disabled when you set [AUTO SWITCH] in [LVF/LCD SWITCH] to [OFF].
[PREVIEW HOLD]
This will set the operation of the [ ] button when displaying the
preview screen.
[OFF]: Preview screen is displayed only when the [ ] is
pressed.
It will return to previous screen when [ ] is released.
[ON]: Preview screen is displayed even after the [ ] is
released after pressing. (P96)
It will return to previous screen when [ ] is pressed
again.
[CONSTANT PREVIEW]
[OFF]/[ON]
[EXPO.METER]
Select whether or not to display the exposure meter when the mode dial is
switched to
³/±/´/² etc.
[OFF]/[ON]
[EXPO. SETTINGS]
Change the method of Exposure Compensation setting switching
when the mode dial is set to , , and .
[SWITCH BY PRESSING THE REAR DIAL]:
Press the rear dial to switch between Exposure Compensation,
Programme Shift, aperture setting, and shutter speed setting.
[SWITCH BY PRESSING THE LVF/LCD BUTTON]:
Press [LVF/LCD] to switch between Exposure Compensation,
Programme Shift, aperture setting, and shutter speed setting.
³
Programme Shift Exposure Compensation
±
Aperture Exposure Compensation
´
Shutter speed Exposure Compensation
²
Shutter speed Aperture
DMC-GH2H&GH2K&GH2EB-VQT3A48_eng.book 133 ページ ２０１０年１０月１４日 木曜日 午後３時５０分
To Next Page
Loading...
