12. Others
308
• When an external flash is attached, the following functions are available in addition to the
functions available with the built-in flash.
– Burst recording (when a setting other than [SH] is selected for [Burst Rate])
– Aperture Bracket
– Focus Bracket
• You can set the aperture value, the shutter speed and the ISO sensitivity on the camera even
when attaching the external flash.
• If you record at close range with a wide angle, light from the flash may be blocked by the lens,
darkening the lower part of the screen.
• Do not use commercially available external flashes with high-voltage synchro terminals,
reverse polarity or functions that enable them to communicate with the camera. Doing so may
cause the camera to malfunction or operate incorrectly.
• When attaching the external flash, do not hold only the external flash because it may detach
from the camera.
• Read the operating instructions of the external flash for details.
By using the AC adaptor (optional) and DC coupler (optional), you can record and play
back without worrying about the remaining battery charge.
The optional DC coupler can only be used with the designated Panasonic AC adaptor
(optional).
•
Always use a genuine Panasonic AC adaptor (optional).
• When using an AC adaptor (optional), use the AC cable supplied with the AC adaptor.
• Also read the operating instructions for the AC adaptor (optional) and DC coupler.
The MC protector is a transparent filter which affects neither the colors nor the amount of
light, so it can always be used to protect the camera’s lens.
The ND filter reduces the amount of light to approximately 1/8th (equal to adjusting the
aperture value 3 increments) without affecting the color balance.
PL filter will suppress the reflected light from a metal or non spherical surfaces (flat
non-metallic surfaces, water vapour or invisible particles in the air), making it possible to
take a picture with enhanced contrast.
•
Do not attach multiple filters at the same time.
• You can attach the lens cap or the lens hood when the filter is attached.
• If you have difficulty attaching or removing the PL filter on the interchangeable lens (H-H020A),
we recommend that you attach or remove the filter with the camera power turned on and the
Focus Mode set to [MF].
• Refer to the instructions for each filter for details.
AC adaptor (optional)/DC coupler (optional)
Filters (optional)
To Next Page
Loading...
Need help?
General
