Recording pictures (advanced)
62
Finely Adjusting the White Balance
If you cannot acquire the desired hue with white balance because of too many
different light sources, etc., adjust the fine white balance as follows.
Preparation
• Set the mode dial except for [ ]/[ ]. (P29)
• Set the white balance to [ ]/[ ]/[ ]/[ ]. (P60)
1 Press 3 until [ WB ADJUST.]
appears.
2 Adjust the white balance.
• 1 [BLUE]: Press when the hue is
reddish.
• 2 [RED]: Press when the hue is
bluish.
• Close the function by pressing 4
after finishing the adjustment.
¬
Suggestions/Tips
¬
• The white balance icon turns red or blue.
• You can set the value independently for
each of the modes in white balance.
• The setting of the fine white balance is
applied to the recording with the flash.
• When you set the white balance using
the White set [ ], the adjustment
level is set to “0”.
• The adjusted picture will be close,
though may not be identical to the
actual picture.
• When setting the color effect to
[COOL], [WARM] or [B/W] (P71), you
cannot adjust the fine white balance.
RED BLUE
WB ADJUST.
EXITSELECT
WB
RED BLUE
WB ADJUST.
EXITSELECT
WB
DMC-LC80.book 62 ページ ２００４年６月１５日 火曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
