Recording pictures (advanced)
63
Setting ISO Sensitivity
The ISO setting sets the cameras sensitivity to light. The ISO setting can be
increased when you need to take pictures in places where a flash may not be
allowed. The overall picture quality will decrease slightly as the ISO setting is
increased.
Preparation
• Set the mode dial except for [ ]/[ ]/[ ]. (P29)
1 Select [SENSITIVITY] and set the
ISO sensitivity.
(The screen illustrated above appears
on DMC-LC70/DMC-LC50. DMC-LC80
has ISO sensitivity between
[80]
–[400].)
• DMC-LC80:
When setting to [AUTO], the ISO
sensitivity is automatically adjusted
from [ISO80] to [ISO200] according
to the brightness. (From [ISO80] to
[ISO400] when using the flash)
• DMC-LC70/DMC-LC50:
When setting to [AUTO], the ISO
sensitivity is automatically adjusted
from [ISO50] to [ISO200] according
to the brightness. (From [ISO50] to
[ISO400] when using the flash)
• Close the menu by pressing the
[MENU] button after finishing the
setting.
¬
Suggestions/Tips
¬
• In Simple mode [ ]/Motion image
mode [ ], ISO sensitivity is fixed to
[AUTO].
• To avoid noises, we recommend
decreasing the ISO sensitivity or
setting [PICT.ADJ.] to [NATURAL].
(P72)
• For the shutter speed, refer to P41.
• When the ISO sensitivity is set to
[ISO400], you cannot use the burst
mode. (DMC-LC80)
• When the ISO sensitivity is set to
[ISO400], the recording interval may
become longer due to the process to
reduce picture noises. (DMC-LC80)
ISO sensitivity
80 400
(DMC-LC80)
50 400
(DMC-LC70/DMC-LC50)
Use in bright places
(e.g. outdoors)
Suitable Not suitable
Use in dark places Not suitable Suitable
Shutter speed Slow Fast
Noises Less Increase
REC
1
/
3
SETUP
W.BALANCE
AUTO
EXITSETSELECT
MENU
WB WB
SENSITIVITY
AUTO 100 200 40050
PICT.SIZE
QUALITY
1600
DMC-LC80.book 63 ページ ２００４年６月１５日 火曜日 午後５時４９分
To Next Page
Loading...
Need help?
General
