Set to ‘SCN1’ or ‘SCN2’
The same selection of 20 scenes is
available for each.
Select scene
1
/
2
SCENE MODE 1
SELECT
PORTRAIT
DISPLAY
SET
Page 1 of
2 currently
displayed
SCENE MENU
To see description of each scene:
Select scene, and press ‘DISPLAY’.
SCN1 and SCN2
When using SCENE MODE, the camera remembers the previously selected scene.
For example, if SCN1 is set to ‘NIGHT SCENERY’ and SCN2 is set to ‘NIGHT
PORTRAIT’, you can easily switch between settings depending on whether or not there
will be people in the picture.
To enable pictures to be taken immediately (no automatic SCENE MENU display)
Display SETUP menu (P.18)
Select ‘SCENE MENU’ (P.22) and set it to ‘OFF’.
To display scene menu: Press ‘MENU/SET’
Note
Selecting a scene mode inappropriate for the actual scene may affect the coloring of
your picture.
Brightness may be adjusted using ‘EXPOSURE’ (P.38) (except in ‘STARRY SKY’ mode).
Detailed settings can be made in REC menu (P.50).
(Except in ‘SENSITIVITY’, ‘METERING MODE’, and ‘COL. MODE’)
Certain settings cannot be made for some scenes.
‘W. BALANCE’ can be set to the following.
‘PORTRAIT’,‘SOFT SKIN’,‘SELF PORTRAIT’,‘SPORTS’,‘BABY’,‘PET’,‘HIGH SENS.’
(Setting is restored to ‘AWB’ when scene is changed.)
The types of flash available (P.36) vary according to the scene.
The scene mode flash setting is reset to the initial setting when the scene mode is
changed.
Guidelines displayed in grey in ‘NIGHT PORTRAIT’, ‘NIGHT SCENERY’, ‘STARRY
SKY’, and ‘FIREWORKS’ scene modes.
MENU/SET
DISPLAY
To Next Page
Loading...
Need help?
General
